​Three major precautions for installing LED point light sources

At present, the use of LED point light sources has become the choice of most people. However, after purchasing the product, you still need to go through an installation step, which is also very critical. Because in addition to the quality of the product itself, whether the installation is in place will also affect the future use. Therefore, it is best to ask professionals to do this work. Specifically, when installing LED point light sources, you need to pay attention to the following three aspects.  

1. Pay attention to the correct connection of the power cord

The power cord should be connected according to the instructions or drawings, and the power supply should be consistent with the working power of the LED point light source, and the light and controller should be well connected. If many LED point light sources are connected, the load of the wire exceeds the original load, then the power cord should be thickened or reconnected to another power cord to ensure stable performance during use.

2. Pay attention to the reasonable installation method

In order to facilitate maintenance later, it is necessary to adopt a suitable LED point light source installation method and arrange the controller and electrical positions reasonably. At the same time, although the LED point light source is used at night, it should also be considered that the installation will not affect the display effect during the day, and at the same time ensure that the product can be well fixed in the corresponding position during installation.

3. Pay attention to inspection

After all the wiring is connected, the LED point light source manufacturer reminds that a comprehensive inspection should be done to ensure that the entire system can be used normally and safely. Therefore, the details should be checked one by one, in case any problems can be solved in time. For example, the wiring connector should avoid touching the wire, and use waterproof tape to separate it for insulation. It is also necessary to check whether the information line is connected in reverse, etc.

The above are three aspects that need to be paid attention to when installing LED point light sources. In addition, you should also pay attention to ensure that the voltage and current used are standard DC. In addition, the LED point light source colorful product manufacturer also introduced that the signal pressure line terminals on the controller must be crimped well, without any looseness or poor contact. Wait until you are completely sure that there is no problem and turn on the switch to check the use situation.